SE-12 Series Electrocardiograph User Manual Introduction
- 21 -
2.6 Bottom Panel
Figure 2-6 SE-12 Express Bottom Panel
Path for sound from speaker
The specification is: T3.15AH250V, Ø5×20mm
T1AL250VP, Ø5×20mm (for UL device)
Path for internal heat emission
Position for product information label
1) Battery Compartment
NOTE: If the battery has not been used for two months or more, you should recharge it
before using it again.
2) Fuse
There are two fuses of the same specification installed on the bottom of the main unit.
WARNING
Ruptured fuses must only be replaced with those of the same type and rating as the
original.