SE-12 Series Electrocardiograph User Manual Transmitting ECG Data
- 43 -
NOTE:
1. This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
2. Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
7.1 Transmitting ECG Data to the PC
ECG data in DAT/PDF/SCP/FDA-XML/DICOM format can be transmitted to the PC. To
transmit ECG data in DAT format, the DMS of the manufacturer must be installed in the PC. To
transmit ECG data in PDF/SCP/FDA-XML/DICOM format, the FTP receiving software must be
installed in the PC.
CAUTION
It is forbidden to connect or disconnect a U disk or a USB printer during the transmission
course.
NOTE: The SCP/FDA-XML/DICOM function can be activated on the Advanced Setup
screen. Password is required to enter the Advanced Setup screen. For details,
please contact the manufacturer or the local distributor.
1. Log into the FTP receiving software.
2. Configure the Transmission Setup window.
1) Press Shift+F1 in the Transmission Setup window to open the Basic Setup window.
2) Set Auto Transmission to On and Transmission Mode to Net Port or Wireless.
3) Set the Server IP item to the IP of the PC.
For details, please refer to Section 10.5.1 "Basic Setup".
To Next Page
Loading...
