EasyManua.ls Logo

EDAN SE-12 Express - Loading Recorder Paper

EDAN SE-12 Express
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SE-12 Series Electrocardiograph User Manual Operation Preparations
- 34 -
Hold down the
key to display the hint System is shutting down on the screen.
Then the device will be off a few seconds later.
NOTE:
1. When turning off the device, follow the above sequence strictly, or else there may be
something wrong on the screen.
2. Do not hold down the
key when the device displays the hint information System
is shutting down on the screen.
3.6 Loading Recorder Paper
NOTE:
1. When the folded thermal paper is used, the paper roller is unnecessary and must be
taken out.
2. When using the paper of 215mm in width, the two movable parts should be removed.
3. The exit edge can help you tear the recorder paper.
4. If the paper with black markers is used, make sure that the markers are on the bottom.
CAUTION
Make sure that the recorder paper, is installed in the center of the recorder, and the paper
edge is parallel with the casing edge in the direction of advancing paper, in order to avoid
paper deviation or damage to the paper edge.
When the recorder paper runs out or is not loaded, the hint message No Paper will appear on the
screen. Then you should load or replace the recorder paper immediately.

Table of Contents

Related product manuals