EDAN SE-12 Express - WIFI Setup (Configurable)

SE-12 Series Electrocardiograph User Manual System Setup
- 56 -
Subnet Mask
Set subnet mask in the format of XXX.XXX.XXX.XXX. XXX is a number
from 0 through 255.
10.5.2 Setup (with Configurable WIFI Module)
NOTE:
1. The WIFI transmission function is only available for the machine configured with the
WIFI module.
2. Data transmission through Wi-Fi is not supported during ECG sampling.
Item
Description
Transmission
Mode
Choose from: Net Port, UART (Ymodem), or Wireless.
Auto Get IP
Select this item, addresses of Local IP, Gateway and Subnet Mask will be
acquired automatically after the wireless network is connected successfully.
NOTE:
1. Only if WIFI is disabled, can Auto Get IP option be available.
2. To use Auto Get IP, DHCP function needs to be enabled on the router.
Enable WIFI /
Disable WIFI
Enable or disable WIFI connection.
Add WIFI
Add new WIFI to the network connection.
View MAC
Address
View the MAC address of the WIFI module.
UP
Select wireless network in the upward direction.
DOWN
Select wireless network in the downward direction.
Refresh
Re-search the wireless network in the area.
Connect
Connect the selected wireless network.
SECURITY
Displays the encryption type for the connected wireless network.
NOTE: Though SE-12 Express supports WEP encryption, we do not
recommend the usage of WEP given the known security issues with
the WEP protocol. The recommended WIFI encryption modes are
EAP, WPA or WPA2.