EDAN SE-12 Express - Chapter 5 Entering Patient Information; Entering Patient Information Manually; Entering Patient Information by Using a Reader (Configurable); Entering Patient Information by Acquiring Orders

SE-12 Series Electrocardiograph User Manual Entering Patient Information
- 40 -
Chapter 5 Entering Patient Information
5.1 Entering Patient Information Manually
1. Configure the Patient Information Setup window. (Configurable)
For details, please refer to Section 10.4 "Patient Information Setup".
2. Select Patient on the main screen1 to open the Patient Information window.
5.2 Entering Patient Information by Using a Reader (Configurable)
1. Configure the bar code
For more detailed information about configuring the bar code, please contact the
manufacturer or the local distributor.
2. Connect the bar code reader, social security card reader, or ID card reader to USB socket 2
on the right panel of the electrocardiograph.
3. When the main screen is displayed, scan the patient's bar code with the appropriate reader,
and then the patient information will appear in the corresponding region.
NOTE: Use the recommended bar code reader in Chapter 15 Accessories.
Recommended social security card reader: T6-ULD-I, USB socket;
Recommended ID card reader: GTICR100-02, USB socket.
5.3 Entering Patient Information by Acquiring Orders
NOTE: To use the order function, the ECG data management software (DMS) of the
manufacturer must be installed in the PC.
1. Connect the electrocardiograph to the PC with Ethernet cable recommended by the
manufacturer.
2. Log into the DMS.
3. Set Server IP, Local IP, Gateway and Subnet Mask in the Transmission Setup window.
4. Select Order Acquired function in Setup-> Patient Info
5. Open the Patient Information window.
6. Enter the patient ID manually in the ID textbox or connect a bar code reader, press Order,
and then the matched order will be loaded from the DMS and the order information will be
displayed in the corresponding textboxes.