Chapter 4
| System Management Commands
File Management
– 102 –
General Commands
boot system
This command specifies the file or image used to start up the system.
Syntax
boot system
{
config
|
opcode
}: filename
config
* - Configuration file.
opcode
* - Run-time operation code.
filename - Name of configuration file or code image.
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
â—†
A colon (:) is required after the specified file type.
â—†
If the file contains an error, it cannot be set as the default file.
Example
Console(config)#boot system config: startup
Console(config)#
Related Commands
dir (107)
whichboot (108)
copy
This command moves (upload/download) a code image or configuration file
between the switch’s flash memory and an FTP/SFTP/TFTP server. When you save
the system code or configuration settings to a file on an FTP/SFTP/TFTP server, that
file can later be downloaded to the switch to restore system operation. The success
of the file transfer depends on the accessibility of the FTP/SFTP/TFTP server and the
quality of the network connection.
Syntax
copy
file
{
file
|
ftp
|
running-config
|
sftp
|
startup-config
|
tftp
}
copy ftp
{
add-to-running-config
|
file
|
https-certificate
|
public-key
|
running-config
|
sftp
|
startup-config
}
copy running-config
{
file
|
startup-config
|
tftp
}
To Next Page
Loading...
Need help?
General