Chapter 14
| Port Mirroring Commands
RSPAN Mirroring Commands
– 411 –
show rspan
Use this command to displays the configuration settings for an RSPAN session.
Syntax
show
rspan session
[session-id]
session-id – A number identifying this RSPAN session. (Range: 1)
Three sessions are allowed, including both local and remote mirroring,
using different VLANs for RSPAN sessions.
Command Mode
Privileged Exec
Example
Console#show rspan session
RSPAN Session ID : 1
Source Ports (mirrored ports) : None
RX Only : None
TX Only : None
BOTH : None
Destination Port (monitor port) : Eth 1/2
Destination Tagged Mode : Untagged
Switch Role : Destination
RSPAN VLAN : 2
RSPAN Uplink Ports : Eth 1/3
Operation Status : Up
Console#
To Next Page
Loading...
Need help?
General