Chapter 4
| System Management Commands
SMTP Alerts
– 132 –
The following example displays settings for the trap function.
Console#show logging trap
Global Configuration:
Syslog Logging : Enabled
Remote Logging Configuration:
Status : Disabled
Facility Type : Local use 7 (23)
Level Type : Debugging messages (7)
Console#
Related Commands
show logging sendmail (136)
SMTP Alerts
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
Table 22: show logging trap - display description
Field Description
Global Configuration
Syslog logging Shows if system logging has been enabled via the logging on
command.
Remote Logging Configuration
Status Shows if remote logging has been enabled via the logging trap
command.
Facility Type The facility type for remote logging of syslog messages as specified in
the logging facility command.
Level Type The severity threshold for syslog messages sent to a remote server as
specified in the logging trap command.
Table 23: Event Logging Commands
Command Function Mode
logging sendmail Enables SMTP event handling GC
logging sendmail
destination-email
Email recipients of alert messages GC
logging sendmail host SMTP servers to receive alert messages GC
logging sendmail level Severity threshold used to trigger alert messages GC
logging sendmail source-
email
Email address used for “From” field of alert messages GC
show logging sendmail Displays SMTP event handler settings NE, PE
To Next Page
Loading...
Need help?
General