Chapter 8
| Authentication Commands
802.1X Port Authentication
– 245 –
Example
Console(config)#dot1x system-auth-control
Console(config)#
Authenticator Commands
dot1x intrusion-action
This command sets the port’s response to a failed authentication, either to block all
traffic, or to assign all traffic for the port to a guest VLAN. Use the
no
form to reset
the default.
Syntax
dot1x intrusion-action
{
block-traffic
|
guest-vlan
}
no dot1x intrusion-action
block-traffic
- Blocks traffic on this port.
guest-vlan
- Assigns the user to the Guest VLAN.
Default
block-traffic
Command Mode
Interface Configuration
Command Usage
â—†
For guest VLAN assignment to be successful, the VLAN must be configured and
set as active (see the vlan database command) and assigned as the guest VLAN
for the port (see the network-access guest-vlan command).
â—†
A port can only be assigned to the guest VLAN in case of failed authentication,
if switchport mode is set to Hybrid.
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x intrusion-action guest-vlan
Console(config-if)#
To Next Page
Loading...
Need help?
General