Edge-Core ECS2100-10P - Loopback Detection Trap; Loopback-Detection Transmit-Interval

Chapter 16 | Loopback Detection Commands
– 420 –
Example
Console(config)#loopback-detection recover-time 120
Console(config-if)#
loopback-detection
transmit-interval
This command specifies the interval at which to transmit loopback detection
control frames. Use the
no form to restore the default setting.
Syntax
loopback-detection transmit-interval seconds
no loopback-detection transmit-interval
seconds - The transmission interval for loopback detection control frames.
(Range: 1-32767 seconds)
Default Setting
10 seconds
Command Mode
Global Configuration
Example
Console(config)#loopback-detection transmit-interval 60
Console(config)#
loopback detection
trap
This command sends a trap when a loopback condition is detected, or when the
switch recovers from a loopback condition. Use the
no form to restore the default
state.
Syntax
loopback-detection trap [ both | detect | none | recover ]
no loopback-detection trap
both
- Sends an SNMP trap message when a loopback condition is
detected, or when the switch recovers from a loopback condition.
detect - Sends an SNMP trap message when a loopback condition is
detected.
none - Does not send an SNMP trap for loopback detection or recovery.
recover - Sends an SNMP trap message when the switch recovers from a
loopback condition.
Default Setting
None