Chapter 4
| System Management Commands
Time
– 138 –
SNTP Status : Enabled
SNTP Server 137.92.140.80 0.0.0.0 0.0.0.0
Current Server: 137.92.140.80
Console#
Related Commands
sntp server (138)
sntp poll (138)
show sntp (139)
sntp poll
This command sets the interval between sending time requests when the switch is
set to SNTP client mode. Use the
no
form to restore to the default.
Syntax
sntp poll
seconds
no sntp poll
seconds - Interval between time requests. (Range: 16-16384 seconds)
Default Setting
16 seconds
Command Mode
Global Configuration
Example
Console(config)#sntp poll 60
Console#
Related Commands
sntp client (137)
sntp server
This command sets the IP address of the servers to which SNTP time requests are
issued. Use the this command with no arguments to clear all time servers from the
current list. Use the
no
form to clear all time servers from the current list, or to clear
a specific server.
Syntax
sntp server
[ip1 [ip2 [ip3]]]
no sntp server
[ip1 [ip2 [ip3]]]
ip - IPv4 or IPv6 address of a time server (NTP or SNTP).
(Range: 1 - 3 addresses)
To Next Page
Loading...
Need help?
General