Chapter 20
| ERPS Commands
– 491 –
6.
Enable ERPS: Before enabling a ring as described in the next step, first use the
erps command to globally enable ERPS on the switch. If ERPS has not yet been
enabled or has been disabled with the no erps command, no ERPS rings will
work.
7.
Enable an ERPS ring: Before an ERPS ring can work, it must be enabled using the
enable command. When configuration is completed and the ring enabled, R-
APS messages will start flowing in the control VLAN, and normal traffic will
begin to flow in the data VLANs. To stop a ring, it can be disabled on any node
using the no enable command.
8.
Display ERPS status information: Use the show erps command to display
general ERPS status information or detailed ERPS status information for a
specific ring.
erps
This command enables ERPS on the switch. Use the
no
form to disable this feature.
Syntax
[
no
]
erps
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
ERPS must be enabled globally on the switch before it can enabled on an ERPS ring
using the enable command.
Example
Console(config)#erps
Console(config)#
Related Commands
enable (493)
To Next Page
Loading...
Need help?
General