Chapter 2
| Using the Command Line Interface
CLI Command Groups
– 77 –
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration)
CM (Class Map Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
Loopback Detection Detects general loopback conditions caused by hardware
problems or faulty protocol settings
417
Address Table Configures the address table for filtering specified addresses,
displays current entries, clears the table, or sets the aging time
423
Spanning Tree Configures Spanning Tree settings for the switch 429
ERPS Configures Ethernet Ring Protection Switching for increased
availability of Ethernet rings commonly used in service
provider networks
489
VLANs Configures VLAN settings, and defines port membership for
VLAN groups; also enables or configures private VLANs,
protocol VLANs, voice VLANs, and QinQ tunneling
459
Class of Service Sets port priority for untagged frames, selects strict priority or
weighted round robin, relative weight for each priority queue,
also sets priority for DSCP
521
Quality of Service Configures Differentiated Services 533
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router; also
configures multicast VLAN registration, and IPv6 MLD
snooping
545
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
605
Domain Name Service Configures DNS services. 629
Dynamic Host
Configuration Protocol
Configures DHCP client and relayfunctions 639
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
651
IP Routing Configures static and dynamic unicast routing 689
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
* ECS2100-10PE/10P/28P/28PP
Table 6: Command Group Index (Continued)
Command Group Description Page
To Next Page
Loading...
Need help?
General