Edimax IC-9000 - Use Camview Software to See the Video; Seeing the Video in a Remote Location

14
2-2 Seeing the Video in a Remote Location
After the IC-9000 is installed and you can see the video from the CamView software in the
local network, it’s very easy to see the video in a remote location. All you need to do is add
a camera item in the “CameraList” 14folder of the CamView software, key in the ID and
Password of the IC-9000 (from the ID/Password card). And then double click this camera
item. You will then see the Camera video immediately. No further NAT/router setting
modifications are needed.