18
3-3 Network
The Network page allows you to modify the network settings of the wired Ethernet. The
default settings use DHCP to obtain an IP address automatically. In most of the home and
office network environment, there is a DHCP server running. In this situation, by using this
default settings, the IP CAM can work immediately in most of the time.
If the Ethernet cable is unplugged, the IP CAM will lose connection. But as soon as the
Ethernet cable is plugged in again, the IP CAM will obtain a new IP address immediately.
If the network environment does not support DHCP function, you will need to set the
network settings of the IP CAM manually. Please fill all the fields including “IP address”18,
“Subnet mask”, “Default gateway”18and “DNS server”18 to let the network work. All these
settings must be correct for your network environment, otherwise the IP CAM cannot work.
The default setting is “obtain an IP address automatically”.
To Next Page
Loading...
