DCP 350 User Manual
20
Card Out Error
<Replay Cancel>
Blinking Blinking Repeat
Cancel &
Initialize
Fail to move the card out
(Check the card in the
printer)
After an error occurs in printing, the error card is not come out
even though "Replay" or "Cancel" button is pressed.
21
DCP350
Download...
On On Firmware downloading
The printer is downloading the firmware. Do not turn off the power
until it is rebooting. It takes about 20 seconds.
22
Board Test Mode
Wait
Test mode state
Test mode which can test the sensors or motors of the printer.
User can set the LED status.
Table1 Status display
To Next Page
Loading...
