DCP 350 User Manual
1.4 LCD panel display & button operation
The DCP 350 printer can show the real-time process status to user. Please refer to the LCD display and the button operation.
LED Button
No LCD Display
Left Right Left Right
State Description
1
Ver X.XX…
Initialize…
On On Initializing Initializing with the indication of firmware version
2
INIT Error xx
<Replay Replay>
Blinking Blinking Repeat Repeat Error during initializing
Showing error no. in case of failure of normal initializing while the
EDIsecure
®
DCP 350 is initialized. (Refer to page13). Press any
keys for re-initializing process.
3
DCP350
Auto Ribbon Set
On On Automatic ribbon setting
It optimizes the ribbon position setting automatically in case of the
replacement of color ribbon(YMCKO or YMCKOK).
4
Auto Ribbon Set
Fail!!!!
Blinking Blinking
Fail to optimize the
ribbon setting
5
Auto Ribbon Set
Color=xxx(xxx)
Blinking Blinking
Fail to optimize the
ribbon setting and
display the ribbon’s color
value
Display these messages when the auto ribbon setting is failed and
it shows the ribbon detecting level.
6
DCP350
System Ready
On On
Installed
ribbon
information
Soft power
ON/OFF
Standby
Printer is ready for printing and you can check the installed ribbon
information by pressing the left button. Printer turns off by pressing
the right button. Printer turns on by pressing the right button when it
turns off.
7
Wait.. 1”C
Temperature=xxx
Blinking Blinking
Printer’s operating
temperature is under
1℃
Shown it when printer’s operating temperature falls down under
1℃. Normal operating temperature is 15℃~35℃.
8
DCP350
Unlock Please..
On On Printer is locked
Physical key option is active using the CardPrinterSetup utility and
it shows the locked state. Unable to print.
9
DCP350
Verify your PC
On On PC is not authenticated
Authentication option is active using the CardPrinterSetup utility.
When use the printer with an unauthenticated PC, it is shown.
Printer is not working.
To Next Page
Loading...
