DCP 350 User Manual
2.2 Loading the cards
This section shows how to load the plastic cards.
Pic.14 Adjusting the card thickness lever
2.2.1.
Open the input hopper cover.
2.2.2.
Adjust the card thickness with the card thickness
control lever.
(Caution! If the adjustment is not correct, it will make
some error. Use the type of cards in the specification
of this manual. Always keep the card surface clean
state.)
Pic.15 Preparing the card 1
Pic.16 Preparing the card 2
2.2.4.
To separate cards from each other, push a stack of
cards back and forth to an angle about 45 degrees
vertically.
(Static charge makes cards stuck with significant
adhesive force. These cards must be physically
separated from each other before inserted into the
feeder. If not separated, feeding or printing problems
may occur.)
To Next Page
Loading...
