DCP 350
④ The EDIsecure
®
DCP 350 Dual side is made by attaching a flipper module to the standard
EDIsecure
®
DCP 350, so you need to adjust it to be tuned in the horizontal. “Rotate Top” is a value
when the card of top side is in line. “Rotate Bottom” is a value when card of bottom side is in line.
Please click “Auto Rotator Set” when an error occurs during a card moved to or from a flipper.
⑤ Please refer as below for other values.
Reserved: Not used
Mag. Write Mode: You can order the way how to encode magnetic stripe.
“L:A, H:I”: encodes 3 tracks at once for LoCo card and encodes at twice by dividing 1,3 and 2 track
for HiCo cards.
Magnetic Space: The distance of magnetic stripe when you encode.
SBS Only: Please enable it when you issue cards with software programmed by SDK. This option
disables printer device driver.
Board Type: to choose the type of mainboard. Please do not change it.
Security: There are several ways to set a security function for the EDIsecure
®
DCP 350.
PC Authentication: You can use a printer with specific PC. It is activated when you click “Set PC
Serial”.
Physical Key: You can set this option when physical key is installed.
User/Root Authentication: You can set passwords for User and Administrator.
Use USB Serial: When the EDIsecure
®
DCP 350 is connected to USB, it transmits the USB serial
number to PC. Default is the same number used by all EDIsecure
®
DCP 350 printers. Please set
this option when you use multiple EDIsecure
®
DCP 350 printers connected to 1 PC via USB. It
enables unique serial numbers for each USB.
Ribbon Position: To set the ribbon position on card. Please set it default.
Card Out Delay: To set timing of hopper motor for ejecting card. Please set it default.
Card Out: to set the way to eject cards.
Error Card Out: to set the way to eject error cards.
DCL Mode: When you use SDK and print cards with DCL mode, you don’t need to install printer
device driver.
Dump Mode: It records log data.
To Next Page
Loading...
