DCP 350
5.2. Contactless smartcard reader
In the EDIsecure
®
DCP 350 printer, you can install the two types of smartcard reader which are the
internal contactless smartcard reader and the external contactless smartcard reader. If you have
one or more contactless smartcard reader devices on your printer, you should install the
contactless smartcard device driver as in the following, and connect EDIsecure
®
DCP 350 printer
to your PC.
5.2.1. Connect EDIsecure
®
DCP 350 printer to PC
When you connect the printer to PC and turn on the printer, you can see the “Found New
Hardware Wizard” as shown in Pic.92, then Check “No, not this time” and Click “Next” to
continue.
Pic.92 Found New Hardware Wizard
5.2.2. Choose the installation method
At the window as shown in Pic.93, select “Install from a list or specific location” and click “Next”.
Pic.93 Installation method selection
To Next Page
Loading...
