DCP 350
The printer’s USB cable is disconnected or the connection is bad.
Check the cable’s connection between PC and the printer.
If not good, connect the USB cable again.
Bad USB cable.
Change the USB cable.
The printing is operated with another printer driver.
Select the correct EDIsecure
®
DCP 350 printer driver again.
Wrong USB port setting of the printer driver.
Check the port setting of the printer driver and change the port setting.
No ribbon in the printer or error occurred.
Install ribbon in the printer or resolve the error.
Too long power or USB cable (more than 1.5M).
Use the cable provided with the printer.
PC’s USB port is down:
Reboot your PC.
To Next Page
