EDMI GS-60B - Page 30

GS-60B Residential Gas Meter - Product Guide
Copyright © 2020 EDMI Europe Ltd. All rights reserved
Version / Status: 1.0
Public
PAGE 30 OF 46
At each stage of the Valve test process, the meter provides visual feedback on the supply state.
For example:
If the valve test is successful, LCD will display success message and the supply state. For
example:
The message will time out after 10 seconds or if dismissed by pressing the OK button and the
screen reverts to Engineering Menu.
If the valve test fails, LCD will display failure message and the supply state. For example:
The message will time out after 10 seconds or if dismissed by pressing the OK button and the
screen reverts to Engineering Menu.
When in this menu, the UI buttons perform the following functions:
Left / Right
No effect.
OK
Initiates the valve test.
Return
Back to parent menu.
11.7.4 Reset Battery
When the battery in the meter is replaced, a command is required to reset the remaining battery
capacity. Hence providing an indication (in the form of an event) to a supplier that the battery has
been replaced.
For information about replacing the battery, refer to section 14.1 Battery Replacement Procedure.
When the menu option is entered2, the screen displays:
P
r
e
s
s
O
K
t
o
s
t
a
r
t
t
e
s
t
T
E
S
T
R
U
N
N
I
N
G
S
U
P
P
L
Y
:
D
I
S
A
B
L
E
D
T
E
S
T
C
O
M
P
L
E
T
E
D
S
U
P
P
L
Y
:
A
R
M
E
D
T
E
S
T
F
A
I
L
E
D
S
U
P
P
L
Y
:
A
R
M
E
D