Edwards CXS 160

This product has been manufactured under a quality management system certified to ISO 9001:2008
Declaration of Conformity
We, Edwards Limited,
Crawley Business Quarter,
Manor Royal,
Crawley,
West Sussex, RH10 9LW, UK
declare under our sole responsibility, as manufacturer and person within the EU authorised to assemble the
technical file, that the product(s)
CXS 160 / EH1200 (50Hz) High Volt System CS65FGH0I0J0
CXS 250 / EH1200 (50Hz) High Volt System CSB5FGH0I0J0
CXS 250 / EH2600 (50Hz) High Volt System CSD56GH0I0J0
Where F = 6, 7 or 8 depending on temperature classification
Where G = 0 or 1 depending on instrumentation
Where H = 0, 2, 7 depending on flame arrester type
Where I = 0, 3 or 5 depending on purge configuration
Where J = 0 or 1 depending on inlet valve
With the following ATEX classification
II 2G IIB3 T3, T160, T4 / 2G IIB T3, T160, T4 X
to which this declaration relates is in conformity with the following standard(s) or other normative document(s)
EN1012-2:1996+A1:2009 Compressors and Vacuum Pumps. Safety Requirements.Vacuum Pumps
EN61326-1:2013 Electrical equipment for measurement, control and laboratory Use. EMC
(Class A Emissions, requirements. General requirements
Industrial Immunity)
EN13463-1: 2009 Non-electrical equipment for use in potentially explosive atmospheres. Basic
method and requirements
EN13463-5: 2003 Non-electrical equipment for use in potentially explosive atmospheres. Protection
by constructional safety ‘c’
EN13463-6: 2005 Non electrical equipment for potentially explosive atmospheres. Protection by
control of ignition sources ‘b’.
EN60079-0: 2009 Explosive atmospheres. Equipment. General requirements.
EN60079-1: 2007 Explosive Atmospheres. Equipment protection by flameproof Enclosures “d”
EN60079-11: 2007 Equipment protection by intrinsic safety “i”
EN50495: 2010 Safety devices required for the safe functioning of equipment with respect to
explosion risks
EN50581:2012 Technical Documentation for the Assessment of Electrical and Electronic Products
with respect to the Restriction of Hazardous Substances
ENISO16852: 2010 Flame arresters. Performance requirements, test methods and limits for use
EN12874:2001* Flame Arresters – Performance Requirements, Test Methods and Limits of use
*CXS 160 and 250 Pump systems including flame arresters were tested in accordance with this standard. Standard now
withdrawn.
and fulfils all the relevant provisions of
2006/42/EC Machinery Directive
2014/30/EU Electromagnetic Compatibility (EMC) Directive
2014/34/EU ATEX Directive on use in Potentially Explosive Atmospheres
2011/65/EU Restriction of Certain Hazardous Substances (RoHS) Directive
Note: This declaration covers all product serial numbers from the date this Declaration was signed onwards.
08.06.2015, Burgess Hill
Malcolm Gray, Technical Manager - Dry Pumps
Date and Place
P200-07-380
Issue C