Switching the UPS off occurs with the activa-
tion of the OFF button. In doing so, the UPS is
not completely switched off but rather switches
to the STANDBY mode. The UPS output is, of
course, switched off.
The operation display pictured here occurs
according to (6.1.1).
A constant acoustic signal occurs during the
switching off procedure.
6.1.5 Direct switching on/off in the autonomous mode (COLD START)
✓ The device is switched off and not connected to the supply network.
Without the UPS network connection, the
UPS can directly switch to the autono-
mous mode by activation of the ON button.
The loads will be, as usual, switched on.
The operation display (green) here blinks in
10 second intervals if the accumulator still
has sufficient charge. If the battery bank is
almost completely empty, the display blinks
at second intervals.
The acoustic signaling accompanies the
autonomous mode as usual.
If the OFF button is now activated during this operating mode, the UPS switches
off completely again.
If, however, the mains power supply is switched on during this operating mode,
the UPS autonomously switches to the standard operating mode according to
(6.1.2).
To Next Page
Loading...
