7Service Guide: EFI Fiery Central integrated server
Introduction
WAARSCHUWING: Til de afdrukserver nooit op door het bovenpaneel vast te nemen. Het bovenpaneel kan het
gewicht van het systeem niet dragen.
• The FC integrated server contains hazardous moving parts. When servicing the FC integrated server, keep away
from moving fan blades.
• Only use the power cord that shipped with the FC integrated server or an appropriate replacement power cord
available from an authorized provider.
• Always disconnect the power cord from the FC integrated server connector panel before opening the unit and
servicing internal components.
• Do not pull on the power cord when unplugging the FC integrated server. Instead, pull the plug.
• Do not place objects on the power cord. Place the power cord away from foot traffic.
• Do not tamper with or disable the power cord grounding plug.
• Do not use a 3-prong adapter in a 2-hole, ungrounded outlet.
• Do not use an extension cord.
• Do not plug the FC integrated server into a circuit with heating or refrigeration equipment (including water
dispensers).
• Do not plug the FC integrated server into a switchable power outlet. This can result in the FC integrated server
being turned off accidentally.
• Never set any liquid on or near the FC integrated server. If liquid is spilled into the FC integrated server, disconnect
the power cord immediately.
• Do not attempt to open the power supply, DVD drive, or hard disk drive.
• Handle the FC integrated server LCD window with care.
If the FC integrated server LCD window breaks and the liquid crystal inside leaks out, avoid contact. If you come in
contact with the liquid crystal, immediately wash it off your skin with soap and water.
• Use care when handling parts of the FC integrated server, as some edges on the unit may be sharp.
• Do not install third-party applications onto the FC integrated server. Third-party applications are not supported
and can cause system problems. Although virus scans are permitted on the FC integrated server, antivirus software
should not be loaded in memory-resident mode.
Warning: The FC integrated server contains hazardous moving parts. When servicing the FC integrated server,
keep away from moving fan blades.
Important: When connecting or disconnecting the power cord:
To Next Page
Loading...
Need help?
General
