9Service Guide: EFI Fiery Central integrated server
Introduction
• During service to the motherboard, avoid using excessive force and always place the motherboard on a
grounded, non-metallic, antistatic surface. Never allow any metal to touch the solder contacts on the underside
of the motherboard, especially beneath the battery socket. Improper handling can short circuit and permanently
damage the motherboard.
• Handle printed circuit boards by their opposing edges only and avoid touching the contacts on the edge of the
board.
Tools you will need
To install or service the FC integrated server, you will need the following tools and parts:
• ESD wrist grounding strap and antistatic mat
• Flathead screwdriver
• #0, #1, and #2 Phillips head screwdrivers
• Needlenose pliers
• FC integrated server documentation, including the customer media pack and any related service bulletins
Important: Avoid touching magnetic tools to storage media such as hard disk drives. Contact between magnetic
tools and magnetic storage media may result in data corruption.
To Next Page
Loading...
