E-connect S has 4 operation modes: FWD, REV,
REC and ATC (See chapter 5.3 Terms and
definition to get the explanations of these
modes).
When choice REV mode, a slow beep alarm
sound appears after starting the motor, used for
indicating counter clockwise rotation happening.
Repeatedly press S to check all the next level parameters of this operation
mode are expected, press < or > to change if not.
The parameter will differ in difference mode according to certain logic (See
chapter 6.5 Parameter logic).
The speed setting can be adjusted from 120 rpm to
1000 rpm.
The speed of REC and ATC operation mode is
difference according to certain logic (See chapter
6.5 Parameter logic).
The torque setting can be adjusted from 0.5 N·cm
to 4.0 N·cm, and R.L (torque reverse less) is also
available.
The torque of REC and ATC operation mode is
difference according to certain logic (See chapter
6.5 Parameter logic).
When choice R.L (torque reverse less), a slow
beep alarm sound appears after starting the motor.
To Next Page
Loading...
