Remove the clamp that secures
the wiring to the main electronic
board box.
Take out the board through the
hole after removing the back cover
of the washing machine.
Remove the connectors of the
power cable from main board.
Remove the connectors and the
faston that connects the earth
(beware as it is fitted with an anti-
sliding stop). Remember to use the
Unhook the hooks that join the two
casings on one side and lift the lid.
Release the hooks that secure the
board to the container and remove
it (take care not to break the
Remove the connectors.
Repeat these steps in the reverse
order.
Once you have inserted the
connectors, make sure the wiring
is inside the box. So that when the
lid is closed, the wiring is not
crushed or cut by the two plastic
parts.
23.4.8 Uimc
Lay the appliance onto its left side (the side where the detergent dispenser is)
Unfasten the screws fixing the bottom cover to the base.
See paragraph 23.4.7 EWX14931 Main board page 116
Release the two hooks securing
the connectors protection on one
And on the other
remove the connectors protection.
Repeat these steps in the reverse order.
Technical Support - DMM 117/124 599 75 58-67 Rev.04
To Next Page