EasyManua.ls Logo

Electrolux EWM09311 - 15.1 Description of options; ENABLING SUPER RINSE

Electrolux EWM09311
124 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15.1 Description of options
Rinse hold
Stops the appliance with water in the tub before the final spin cycle.
To drain the water, reset the programme and then select a drain or spin cycle.
Pre-wash
Adds a pre-wash phase at the start of the cycle with water heating to 30°C (or cold, if selected).
Available in COTTON cycles, performs a short spin before advancing to the wash phase.
Economy / Energy label
Modifies the structure of the COTTON 40÷90 - SYNTHETIC FABRICS 50/60 programmes to reduce energy
consumption, guaranteeing washing performance levels.
Reduces the washing temperature
Increases the duration of the wash phase
Super rinse
Adds two rinses in the COTTON cycle, adds one rinse in the SYNTHETIC FABRICS - DELICATES cycles
Cancels the end of wash spin and the first two intermediate spins.
The other intermediate spins are limited to 450 rpm with the final spin at maximum speed.
ENABLING SUPER RINSE
Appliances that do not envisage this option associated with a button can enable it
through a key combination (see instruction manual).
Z3 Styling Z6 Styling
During the selection phase, press the two buttons shown in the figure simultaneously
for at least 5 seconds until the related LED comes on. This option also remains
enabled during subsequent cycles. To disable it, press the two buttons simultaneously
for at least 5 seconds until the related LED is turned off.
Easy-iron
In COTTON programmes:
- adds three rinse cycles
- eliminates intermediate spin cycles
- performs a pulse spin phase before the final spin
- adds an untangling phase after the spin cycle
In SYNTHETIC FABRICS programmes:
- it reduces the heating temperature in 50/60°C cycles to 40°C
- increases the wash time
- prolongs the cooling phase at the end of the wash phase
- adds one rinse cycle
- adds an “untangling” phase after the pulse spin cycle
No spin
It eliminates all the spin phases
It adds three rinses to the COTTON cycle and one to the SYNTHETIC FABRICS cycle.
Super quick
Modifies the structure of the wash phase of the COTTON - SYNTHETIC FABRICS - DELICATES cycles by
half a load.
Technical Support - DMM 54/124 599 75 58-67 Rev.04

Table of Contents

Related product manuals