• Delayed Start
→ Adds a pause before the start of the programme. The delay time is indicated by LEDs or the Display
(see page 12 or page 24 button 7/5, for Display or LED display, respectively).
→ To start the cycle immediately after the countdown to the delayed start has already begun:
press the Start/Pause button, cancel the delay time by pressing the relevant button, then press Start/Pause
again.
• Reduced spin speed
Z6 Styling
It can be linked to buttons with 2-5 LEDs, (the possible combinations are shown below):
- Maximum - Maximum declared spin speed.
- Reduction 1 - Reduction of the spin speed to between the maximum speed and the minimum speed
(400 rpm).
- Reduction 2 - Reduction of the spin speed to between the speed of reduction 1 and the minimum speed
(400 rpm).
- Automatic reduction – reduces the maximum speed for the programme by half, but not less than 400 rpm.
- No spin - excludes all spin cycles.
- Rinse hold - excludes only the final spin, but not the intermediate spins and ends the cycle with
water in the tub.
A further spin reduction can be obtained by selecting the “Easy-Iron” option in cotton programmes when the
selected programme envisages a spin speed of more than 900 rpm.
The following tables contain the possible configurations of the “Spin” button depending on the combination of
LEDs.
Intermediate 3
500 700 700
Last selection
Rinse hold Rinse hold Rinse hold
or
or
or
or
or
or
Technical Support - DMM 55/124 599 75 58-67 Rev.04
To Next Page
Loading...
