• Buzzer
The buzzer emits:
→ One “beep” when: selecting programmes, selecting an option, when the START/PAUSE button is pressed to
start or pause the cycle.
→ Three “beeps” when: an option incompatible with the selected programme is chosen, or when a button is
pressed or a dial is turned during a cycle.
→ A particular sequence of “beeps” for a two-minute duration when the cycle has terminated.
→ A particular sequence of three “beeps” to signal an appliance malfunction.
The Buzzer may be configured to sound:
as in the aforementioned cases.
only at the end of the cycle.
only in the event of an alarm.
The volume has a factory preset level and cannot be changed by the user.
In models fitted with a buzzer, the buzzer can be enabled / disabled during programme selection, but alarm
signalling remains enabled.
To enable/disable it, press the buttons simultaneously for 5 seconds. A short beep confirms that it has been
enabled/disabled.
Technical Support - DMM 48/124 599 75 58-67 Rev.04
To Next Page
Loading...
