Electrolux Side-By-Side Refrigerator - Page 13

5
Section A - Installation
2. Remove Hinge Cover screws, then remove cover.
3. Disconnect wiring
harness
connector plug at
top hinge. Place
your thumbs on
flat sides of each
connector,
bending both
sides back and
forth, then with
firm grasp, pull
both pieces apart.
4. Trace around
hinge with soft
lead pencil. This
will make it easier
to realign doors
when they are
reinstalled.
5. Remove top
hinge, allowing
wiring harness to
pull through hinge.
6. Lift freezer door
off bottom hinge
pin. Lay door
down flat to avoid
kinking water line.
7. Remove bottom hinge, if necessary.
8. Reverse this procedure to reinstall freezer door.
Screws
Water
Line
Tubing
Hinge
Assembly
Door