90 Section F - Ice Maker
To Replace Water Fill Switch
1. Remove Ice Maker from Freezer.
2. Remove front Cover.
3. Remove three screws that attach Mounting Plate to Support Housing.
4. Disconnect two Water Fill Switch wire leads.
5. Remove two switch mounting screws.
6. Remove switch.
7. Replace switch in reverse order, ensuring that switch insulator is in place.
8. Check Water Fill Cycle and adjust as required.
To Replace Ejector Blades
1. Remove Ice Maker from Freezer.
2. Remove front Cover.
3. Remove three screws holding Mounting Plate in place.
4. Carefully remove Mounting Plate, disengaging end of Ice Maker Control Arm
and Ejector Blades from Motor coupling, noting relative position of Ice Maker
Control Arm Spring.
5. Remove Fill Trough and bearing.
6. Turn blades to 12 O’clock position.
7. Slide Ejector Blades back and up to remove.
8. Replace in reverse order.
9. Lubricate bearing ends of Ejector with Silicone grease.
To Replace Hold Switch
1. Remove Ice Maker from Freezer.
2. Remove front Cover.
3. Remove three screws that attach Mounting Plate to Support Housing.
4. Disconnect six Hold Switch wire leads.
5. Remove two Hold Switch mounting screws.
6. Remove Hold Switch.
7. Replace in reverse order.
To Next Page
Loading...
