SOI/DT 2010-03 dmm 43/78 599 72 84-41
10.4 Description of options
• Rinse hold
→ Stops the appliance with water in the tub before the final spin cycle.
→ To drain the water, reset the programme and then select a drain or spin cycle.
• Night cycle
→ Eliminates all spin phases and adds three rinses in COTTON cycles and two rinses in SYNTHETIC
FABRICS cycles
→ Stops the appliance with water in the tub before the final spin cycle.
→ Eliminates the buzzer (if configured)
→ To drain the water, reset the programme and then select a drain or spin cycle.
• Pre-wash
→ Adds a pre-wash phase at the start of the cycle with water heating to 30°C (or cold, if selected).
→ In COTTON and SYNTHETIC FABRICS cycles, performs a short spin before passing on to the washing
phase.
→ This option cannot be selected for WOOL and HAND WASH cycles.
• Soak
→ Adds a pre-wash phase with heating to 30°C (or cold, if selected) plus 30’ hold with wool movement.
→ Fills water, goes to the end of the cycle and for a maximum time of 9+9 hours of hold, it performs a wool
movement.
• Stains
→ Adds a 5-minute motor movement phase after heating to 40°C
→ Ducts water to the pre-wash/stains compartment to introduce the special stain-removal product
→ This option cannot be selected for DELICATES, WOOL and HAND WASH cycles.
• Bleach
→ Ducts water through the bleach compartment at the beginning of the first rinse in COTTON cycles.
• Economy / Energy label
→ Modifies the structure of the COTTON 40÷60 - SYNTHETIC FABRICS 50/60 programmes to reduce energy
consumption, guaranteeing the washing performance levels.
→ Reduces the washing temperature.
→ Increases the duration of the wash phase.
• Super rinse
→ Adds two rinses in the COTTON - SYNTHETIC FABRICS - DELICATES cycles
→ Eliminates the intermediate spins except for the last one, which is limited to 450 rpm.
•
Half-load
→ Eliminates one rinse in COTTON programmes.
• Easy-iron
→ In COTTON programmes:
- adds three rinse cycles
- eliminates the intermediate spin cycles
- performs a pulse spin phase
- adds an "untangling" phase after the spin cycle
→ In SYNTHETIC FABRICS programmes:
- reduces the heating temperature in 50/60° cycles to 40°C
- increases the washing time
- prolongs the cooling phase at the end of the washing phase
- adds one rinse cycle
- adds an "untangling" phase after the pulse spin cycle
To Next Page
Loading...
