SOI/DT 2010-03 dmm 46/78 599 72 84-41
Ö Washing cycle tables: each washing cycle consists of a series of phases (steps); the steps are the basic
instructions which comprise the description of the cycle, which is common to all appliances having the same
characteristics.
- Water fill
- Motor movement
- Reset
- Heating
- Drain
- Spin
- Conditions “IF” .... (options, temperatures, etc.)
Ö Configuration of the washing cycle: for each family of appliances, certain parameters associated with the
washing cycle are defined.
- Working limits (voltage/frequency)
- Transmission ratios
- Parameters for control of the signal from the tachometric generator
- Parameters for half-range operation of the motor
- Structure of the washing group
- Control parameters for the FUCS anti-unbalancing system
- Water fill algorithm
- Alarm control system
- Sensor parameters (flowmeter, etc…)
11.1.3 RAM
This memory contains the variables, that is to say all the dynamic information used during running of the
programme:
Ö Motor speed
Ö Temperature of the water
Ö Alarms
Ö Cycle selected
Ö Machine status
The memory is cancelled every time the power supply is disconnected (power failure or appliance switched off).
The contents of the memory can be read using a computer connected via a DAAS interface.
The same system can be used to send commands to the electronic control unit such as:
Ö Select remote control mode
Ö Activate the various loads in remote mode
Ö Select diagnostic mode
Ö Select a cycle and options, and start the cycle
To Next Page
Loading...
