11. Regular maintenance
11
4
438 9145-01/01
00.45
Service
Manual
-Verify that all internal hoses do not leak.
- Inspect the drive belt. Adjust the tension or replace if necessary (see
section 30. Motor).
-Check that water does not leak onto the floor.
- If the heating time is unusually long, check the heating elements (see
section 40. Heating). If the water is very hard, check whether there
are lime deposits on the heating elements. Decalcify the elements if
necessary. Adapt the amount of deliming agent to the manufacturer’s
guidelines.
-Never switch on the heating elements when there is no water in the
machine. This will cause the slow-blow fuse to trigger.
- Inspect the shock absorbers and coil springs.
To Next Page
Loading...
Need help?
General
