12. Troubleshooting
12
31
438 9152-11/03
04.03
Service
Manual
MIS COMMUNICATION
Communication between the programme unit
card A1 and the network has been interrupted.
If the power is on, be very careful when
working on the the machine.
Try to restart the machine (i.e. reset the error
code) by pressing START.
If the error returns, troubleshoot as follows:
Verify that the cable between the network and X7
on programme unit card A1 is connected. If the
cable is properly connected, contact the person
responsible for the network.
Note!
This error code will disappear by itself after
several programme starts. In case
communication has been interrupted
intentionally, the machine can be operated with
no further intervention required.
27
Fig.
27
3972
X7
To Next Page
Loading...
Need help?
General
