12. Troubleshooting
12
26
438 9152-11/03
04.03
Service
Manual
LEVEL CALIBRATION
The water level system has not been correctly calibrated.
Each machine has been individually level adjusted at the factory. If the
calibration values are missing or outside the limits, an error is generator at
programme start. The programme can, however, be started by pressing
START once more. In this case the standard values are used and the level
swill not be as exact.
Carry out programming anew and make sure the calibration values are
within the allowed limits.
To Next Page
Loading...
Need help?
General
