P100
User Manual
9
Maintenance
The reading window must be kept clean. Supplier is exempt from warranty liability for damage
caused by improper maintenance.
Avoid hard and rough objects to scratch the reading window.
Remove the stains from widow with a brush.
Please use a soft cloth to clean the window, such as glasses cloth.
Not spray any liquid on the window.
Not use any cleaner other than cleaning water.
Barcode Read
In manual read mode, the procedure for scanning barcodes is as follows:
(1) Make sure that the scanner, data cable, data receiving host, and power supply are properly
connected and turned on.
(2) Hold down the trigger to activate the light.
(3) Align the aiming line to the center of the barcode, move the scanner and adjust the distance
between it and the barcode to find the optimal scanning distance.
(4) When hear the prompt sound, the infrared light goes out and the barcode reading successfully,
then the scanner will decode the data to the host.
(5) All set barcodes are saved by power outage.
▲Note: For the same batch of barcodes, the scanner keeps a very high success ratio in certain distance
which is regarded as the optimal scanning distance.
Use the Setting Barcode
Set the parameter to a special barcode whose barcode type is barcode128. When it scans to a barcode
software that matches the setting type of setting, it will automatically enter the setting and does not
send the results on the host. All set barcodes are saved by power outage. (except to restore factory
settings)
To Next Page
Loading...
