P100
User Manual
29
Code 11
Enable/Disable code 11
Enable Disable (Default)
Check Setting
Code 11 barcode data does not contain the check digit. If there is a check digit, it can be the last
one or two characters of the data. The check bit is the value calculated from all data to check whether
the data is correct. Therefore, if it is set to "Not check", the reader will normally transmit all barcode
data.
Not check (Default)
1-bit check 2-bit check
Transmit check character
Transmit check character Disable (Default)
Code 128
Enable/Disable code 128
Enable (Default) Disable
Note: if this barcode is set to disable, the scanner will not be able to scan and switch the
corresponding function settings.
To Next Page
Loading...
