P100
User Manual
21
Continuous
Single Reading Time Limit
In continuous mode, it indicates the maximum time of scanner continuously collect and identify
barcode before reading successfully. If it times out, it will enter the interval of not collecting and
reading according to the setting. The code reading time is 100ms in units, which can be set to
0.1~9.9s.
When it be set to 0 that indicates no waiting. Please refer to chapter 7 of the setting method.
Command Programming
In this mode, scanner needs the host to trigger and decode the barcode. The scanner can set the
length of the reading time. The reading code time can be set to 0.1~9.9s. When it be set to 0 that
indicates no wait. Please refer to chapter 7 of the setting method.
To Next Page
Loading...
