NOTICE
A dirty outer element should be discarded, not
cleaned for further use. Cleaning an element voids
the warranty and makes the element less effective.
3. If the outer element is dirty, replace it with a
new one.
NOTICE
A loose, damaged or missing seal will allow dust to
clog the inner element.
4. Check the rubber seal on the open end of the
outer element. If the seal is loose, damaged or
missing, replace the element with a new one.
NOTICE
If a new outer element must be installed, a new
inner element must also be installed.
5. Visually inspect the inner element while it is
in the canister. If the inner element is dirty,
remove it and install a new one. The inner ele-
ment cannot be cleaned.
6. Visually check the rubber dump valve and
pinch the lips of the valve to remove any accu-
mulation of debris.
7. Before installing a new or cleaned element,
clean the inside of the air cleaner canister with
a damp, lint-free cloth.
SERVICE
PROCEDURES
SP-6
Figure SP-4
Air Cleaner
To Next Page
Loading...
