3. Move the side brooms in using Side Broom In /
Out (right - #1, left - #5).
4. Set Sweep/Transport Circuit Select (#19) to
transport.
Air springs on the rear axle will automatically raise
the sweeper when the sweeper is switched to
transport mode. This will provide smoother,
more comfortable ride, utilizing full suspen-
sion.
When the sweeper is put into sweep mode, the air
springs will automatically lower to provide
solid rear axle support during sweeping and
optimal stability for dumping.
SWEEPING
1. Before engaging sweeping components, bring
the Eagle to a complete stop and idle the
engine at 1000 rpm.
2. Select left or right steering using Steering
Circuit Control (#14).
NOTICE
Never operate the starter for more than 10 seconds.
Longer operation will lead to an over discharge of
the batteries, as well as starter seizure. Wait at least
30 seconds between attempts to start the engine.
3. Start the engine by turning the auxiliary igni-
tion switch (#17) clockwise as far as it will go.
Hold the switch in that position until the
engine begins running, but no longer than 10
seconds. If the engine fails to start within 10
seconds, wait at least 30 seconds before trying
again.
O-11
OPERATION
To Next Page
Loading...
