STOPPING THE SWEEPER
When stopping the sweeper, use the Engine
Throttle Control to set the engine speed to Idle
(1000 rpm). Allow the engine to idle for a few min-
utes. The exact length of time will vary according to
the temperature of the air and the temperature of
the engine.
This idling time will allow the lubricating oil and
coolant to cool the combustion chambers, bearings,
shafts, etc.
NOTICE
Engine speed must be reduced to idle (1000 rpm) for
at least two minutes before shutdown. Failure to let
the engine cool down will result in severe damage to
the turbocharger.
AT END OF SHIFT
At the end of each shift the sweeper must be thor-
oughly washed down for continued high perfor-
mance.
After washdown is complete, daily maintenance
must be performed.
Complete instructions for washdown and daily
maintenance can be found in the Service
Procedures Section.
OPERATION
O-20
To Next Page
Loading...
