7. Remove and clean battery. Store in a cool, dry
place and keep fully charged.
8. Clean the exterior of the equipment and touch-
up any scratched or chipped painted surfaces.
9. Seal all openings on engine with plastic bags
and tape.
10. Coat all exposed metal surfaces with grease or
corrosion inhibitor.
SPRING START-UP
Follow all directions of the engine manufacturer for
start-up of equipment.
1. Remove all protective coverings, including
those on engine and electrical systems.
2. Install fan and alternator belts, if they were
removed. Inspect belts and replace them if
they show cracks, stretching or fraying. Adjust
belts to their proper tension.
CAUTION
Gas given off by batteries is explosive. Keep
sparks and flames away from battery. Always
use a voltmeter or hydrometer to check battery
charge. Always remove grounded (-) battery
clamp first and replace it last.
3. Remove battery from storage. Install fully-
charged battery and connect cables.
4. Install the plug in the water tank drain.
To Next Page
Loading...
