When this field is set and the <#> Key is pressed, the Set Date
Command is complete and the display jumps back to: -
The <B> Key brings you to the Set Time Command. The following
display is shown when you press the <B> Key.
Hour Minute Second
With the cursor blinking in the hour field.
Enter in the correct hour followed by the <#> Key. Note that this is
a 24-hour clock so that all afternoon hours should be added with
12. (E.g. 4 p.m. is entered as 16 hours). Note again that you must
key in a 2-digit number so 4 a.m. is entered as 04 and not 4.
Remember to press the <#> Key after entering the desired value.
Again you can use the <*> Key to correct any wrong entry.
Now enter the ‘minutes’ value followed by the <#> Key.
Finally enter the ‘seconds’ value followed by the <#> Key. Note that
you may abort at any time by pressing the <*> Key.
To Next Page
