The default setting is to record all events. If you desire to record
only selected activities, you should press "D" to change the
setting to "NO" followed by <#>. Now the screen will show: -
As an example, to set the equipment to record only valid entry
(transaction code 0) and valid exit (transaction code 9) key in "0"
key twice. Note that when you press it the first time, nothing (or
“space”) appears because the keypad is now in the alphanumeric
mode. When you press it again, it changes to "0". Press the right
arrow key "C" to shift the cursor one position to the right and press
"9" key thrice. The screen will now look as follows: -
Press <#> to accept the setting.
4.4
DOOR MENU
There are 5 commands in this menu. The commands under DOOR
MENU concerns operations related to the door.
To Next Page
