Elid EL2315D - Automatic Operation of Sensing Inputs

Chapter 4 – User Menu
EL2315D & EL2316D Door Controller Manual
You should enter the sensor number as before.
If Arm Sensor Command is selected, then the screen will show: -
Press the <#> Key to confirm arming of sensor point. (Press the
<*> Key to abort)
If Disarm Sensor Command is selected, then the screen will show: -
Press the <#> Key to confirm.
4.5.2 Automatic Operation Of Sensing Inputs
It is possible to automatically arm and disarm a sensor by setting
the "SENSOR TZ" (Sensor Time Zone). When this command is
executed, the screen will show: -
Set
Sensor TZ
01
SUN:00
MON: 00
Sensor #
Day Timer
Day
Timer
Of
Of
Week
Week
You may choose the timer to be used for each day of the week
and holiday by keying the timer number one at a time. For
example, if sensor point 1 is connected to a Passive Infra Red
detector which should be armed between 6 p.m. and 6 a.m. each
night, then timer setting as below should be used for all days of
the week, as well as holidays.
Timer
Set 1
Set 2
Revision 1.1.21
67
Arm Sensor
Confirm ( * / # )
Disarm Sensor
Confirm ( * / # )