E-NE If the controller is set to "Inhibit Access" mode, then only
certain category of users can gain entry. All cards of
lower category will not be granted entry, and the display
will show "E-NE", Error-No Entry.
E-AP If the controller is set to Anti-Passback mode, and an
antipassback violation occurs, the display will show E-AP.
E-LO If wrong PIN number is keyed in repeatedly for a given
card and the number of mistakes exceeds the
preprogrammed limit, the card is locked out. E-LO means
Error-Locked Out.
PIN If the controller requires PIN number to be entered.
E-IP This indicates that an incorrect PIN number has been
entered.
GO This indicates that the door has been unlocked.
1.1.2
Door Sensor
The Door Sensor is a device for detecting whether the door is open
or closed. It is linked to the controller.
1.1.3
Electric Door Lock
The Electric Door Lock is an electromagnetic device used to lock
or unlock a door. When the device is "activated", the door can be
opened. When it is "deactivated", it cannot be opened. There are
many different types of door locks in use depending on the type of
door it has to control.
The EL2316D Controller controls the Door Lock.
1.1.4
Miscellaneous Inputs / Outputs
The controller may optionally be connected to an interface panel
where various types of alarm outputs, control outputs and status
To Next Page
