inputs are connected. EL2316D can support 2 units of EA8 (with 2
inputs and 6 outputs). First EA8 is related to Door 1 and second
EA8 is related to Door 2. If your installation does not use these
devices, ignore this section.
a)
Input Sensors :
The EL2316D Controller has 2 input points that may be
connected to other equipment to monitor their status. These
points are referred to as Input Sensor Points #1 and #2.
b)
Outputs:
EL2316D is equipped with 7 outputs. Out of these, 6 outputs
may be individually programmed to be operated by any input
condition.
In addition, EL2316D can also operate in the EL2000 emulation
mode, in which case, the 7 outputs are automatically configured as
follows: -
i. GP Outputs (General Purpose Outputs) :-
2 output points may be connected to other equipment to
control their operation. These 2 points are referred to as
GP Output #1 and GP Output #2.
ii. Door Shunt Output :-
This is an output point, which is activated each time
there is a valid entry and will only deactivate when the
door is closed. It can be used to shunt a door alarm
contact monitored by a separate alarm system.
iii. Sensor Armed Output :-
The input sensors described previously may be used as
burglar alarm inputs. In this case, you can arm or disarm
the points. When the points are armed, the Sensor
Armed Output is switched on (activated). This point can
only be connected to an LED indicator light.
To Next Page
